Avaya S8100 Series Manual page 1093

2. Connect a CAT5 or better Ethernet cable to the top RJ45 jack on the media processor I/O
adapter. This jack is labeled Port 1.
3. Connect the other end of the CAT5 cable to an RJ45 jack on the customer LAN.
Connecting CLAN cables
You can install the CLAN circuit packs in any universal port slot.
To connect a CLAN slot to the LAN:
1. Connect the TN799DP I/O adapter to the backplane amphenol connector that corresponds
to the slot in which the TN799DP is installed.
2. Connect a CAT5 or better Ethernet cable to the RJ45 jack on the TN799DP I/O adapter.
3. Connect the other end of the CAT5 cable to an RJ45 jack on the customer LAN.
Administering the new circuit packs
!
Important:
In addition to the administration procedures described in this section, you might
Important:
also need to adjust the administration of the network regions. Your planning
documents might provide information about changes to network regions. For
more information on how to administer network regions, see Administration for
Network Connectivity, 555-233-504.
Tip:
To avoid the loss of new translations, save translations frequently during the
Tip:
administration process.
Administering the IPSI circuit packs
To administer the TN2312BP circuit packs:
Note:
You must complete steps 1 and 2 just once for all IPSIs. Repeat the remaining
Note:
steps for each IPSI.
1. If any of the IPSIs in the configuration are duplicated, enter change
system-parameters duplication to set Enable Operation of IPSI Duplication to y.
2. Enter change system-parameters ipserver-interface to set the Switch
Identifier for the IPSIs on this system. This identifier is usually A. If the identifier is not A,
enter the correct value as a letter B to J in the Switch Identifier field and press Submit.
Note:
Repeat steps
Note:
3. To add a new IPSI, enter add ipserver-interface n, where n is the PN number.
3 and 4 for each new IPSI.
Conversion Tasks
Issue 2.1 June 2006 1093