Avaya S8100 Series Manual page 636

Migrating a DEFINITY Server CSI in a CMC to an S8700-Series Media Server with IP-PNC
!
CAUTION:
If the information in either the Primary Control Subnet Address fields, the
CAUTION:
Secondary Control Subnet Address field, or both, is incorrect, you must
change the information on the media servers. Use the Maintenance Web
Interface. Under Server Configuration and Upgrades, click Configure Server to
change the media server configuration. Then return here to perform Step 3.
3. Verify that the Switch Identifier field is set correctly for this installation. The correct Switch
Identifier must be entered here before you administer the TN2312 IPSI circuit packs.
4. Verify that the IPSI Control of Port Networks field is set to disabled.
5. Press Enter to submit the screen.
Note:
The information that you provide depends on whether the IPSIs get static
Note:
addresses or the addresses are assigned automatically through DHCP.
Adding IPSI information
To add IPSI information:
1. Type add ipserver-interface PNnumber where PNnumber is the port network
number. Press Enter.
2. When you use static addressing, in the Host field, type in the IP address for the IPSI in the
port network that is listed in the Location field.
3. Verify that all the other fields are populated.
4. Press Enter to put the changes into effect.
5. Repeat Steps 1 through 5 for each port network.
Setting IPSI duplication (high-reliability critical-reliability only)
To set IPSI duplication:
1. Type change system-parameters duplication. Press Enter.
2. Set the Enable Operation of IPSI Duplication field to y.
3. Press Enter to put the changes into effect.
636 Upgrading, Migrating, and Converting Media Servers and Gateways