Avaya S8100 Series Manual page 1166

Installing or converting to an S8500 LSP
Checklist
Note:
For the conversion scenario, this procedure assumes that service provided by the
Note:
S8500 Media Server has been migrated to an S8700-series Media Server. The
S8500 is therefore placed out of service and reinstalled as an LSP. For more
information, see
page 871.
To install a new S8500 LSP or convert an existing S8500 primary controller to an LSP server,
perform the following tasks:
1. Installing the hardware (new installation only)
2. on page 1167
3. Connecting the laptop and turning on the media server
4. Configuring the SNMP modules in the UPS
5. Configuring the SNMP subagent in the Avaya Ethernet switch
6. Disabling the boot timeout of the SAMP board (S8500B upgrade only)
7. Installing Avaya Communication Manager
8. Configuring the S8500 LSP
9. Configuring the RMB
10. Installing SAMP software update, if necessary
11. Configuring the modem
12. Administering the new primary controller
13. Enable license server capability on a media gateway, if necessary
14. Install and verify the license on the new LSP
15. Opening the TCP ports on the S8500 LSP
16. Connect the new S8500 LSP to the LAN/WAN
17. Reset the S8500 LSP
18. Verify that the primary controller identifies the new LSP and has sent the translations
page 1179
19. Readminister the desired media gateways to point to the LSP
1166 Upgrading, Migrating, and Converting Media Servers and Gateways
Migrating an S8500 Media Server to an S8710 Media Server
on page 1169
on page 1171
on page 1172
on page 1174
on page 1174
on page 1177
on page 1179
on page 1167
on page 1167
on page 1168
on page 1168
on page 1173
on page 1176
on page 1179
on page 1180
on
on page 1168
on page 1176
on