Avaya S8100 Series Manual page 876

Migrating an S8500 Media Server to an S8710 Media Server
!
CAUTION:
You must stop call processing on the LSPs during the migration process. You can
CAUTION:
stop call processing on the active media server. If you do not stop call processing
on the LSPs, all calls to the LSPs will be dropped.
Migration tasks
The information in this section is based on the assumption that the media server complex is
installed, configured, and operational.
On the S8500 Media Server
Clearing the ARP cache on the laptop computer
You might need to clear the Address Resolution Protocol (ARP) cache before you enter a new
IP address. This need depends on the operating system on your laptop computer. If you enter
an IP address and your computer cannot connect, you might need to clear the cache.
To clear the ARP cache on the laptop:
1. Click Start > Run to open the Run dialog box.
2. To open an MS-DOS command line window, type command. Press Enter.
3. Type arp -d 192.11.13.6. Press Enter. This command produces one of the following
responses:
The command line prompt displays when the cache is cleared.
●
The message The specified entry was not found appears when the specified IP
●
address does not currently appear in the ARP cache.
4. To access the media server, type ping -t 192.11.13.6. Press Enter.
The -t causes the ping to repeat until you get a response. When you get a response, in
about 3 minutes, wait an additional 30 seconds before you go back to the Web interface.
5. To stop the ping, type ctrl c. Press Enter.
6. Close the MS-DOS window.
876 Upgrading, Migrating, and Converting Media Servers and Gateways