Avaya S8100 Series Manual page 420

Migrating from an IP600 or S8100 to an S8400 Media Server using ftp
Presite migration checklist
Before you go on site, complete the following tasks:
Task
Verify that the voice network,
dial plan, and E911 for remote
locations were redesigned.
Verify that all existing circuit
packs work with the new
system.
Replace any TN799B/C C-LAN
circuit packs.
Replace the 259A adapter and
the CAT3 cable.
Replace TN570 EI circuit packs.
On site migration checklist
When you are on site, complete the following tasks before you start the migration:
Task
Verify that you have the
correct cables for the
TN8412AP S8400 Internet
Protocol Interface (SIPI)
circuit packs.
Verify that you have all
necessary equipment
onsite.
420 Upgrading, Migrating, and Converting Media Servers and Gateways
Description
Perform this task only if applicable.
Check the Minimum Vintage Table. Go to the
Hardware and Software Compatibility Matrix at ftp//
ftp.avaya.com/incoming/Up1cku9/tsoweb/media/
minhardwarevintages.pdf.
Replace with the TN799DP circuit pack.
Replace with the cable extender adapter with
Comcode 848525887 and the CAT5 or better cable.
Replace with TN570B vintage 7 or later circuit packs.
Description
The cables must be labeled and run from the control
hardware rack to the port networks. Appropriate
connectivity must be provided.
For the list of required hardware, see Installing and
Configuring the Avaya S8400 Media Server
(03-300678).