Avaya S8100 Series Manual page 847

Connecting to the processor
To connect to the processor:
Note:
You need a cross-over cable to connect your Services laptop directly to the
Note:
processor.
1. Perform one of the following actions to connect the Services laptop directly into the Avaya
IP600 processor circuit pack:
If the processor circuit pack is a TN795, place the NIC card into the slot on the faceplate.
●
If the processor circuit pack is a TN2314, plug the RJ45 connector directly into the RJ45
●
jack on the faceplate.
2. Start a terminal emulation application or Avaya Site Administration.
3. Log in as lucent3.
Recording node names and IP addresses
To record node names and IP addresses:
1. Note the node names and the IP addresses that are assigned to the TN2302AP IP Media
Processor and the TN799C/DP C-LAN circuit packs. Ensure that these names and
addresses are the same after the migration.
Note:
If the existing system has TN799C C-LAN circuit packs, you must replace these
Note:
circuit packs with TN799DP circuit packs.
2. To get the node names for the TN2302AP IP Media Processor and TN799C/DP C-LAN
circuit packs, type display ip-interfaces. Press Enter.
3. To get the IP addresses that match the node names, type list node-names. Press
Enter.
4. Record the information for use after the migration.
Premigration administration
Issue 2.1 June 2006 847