Differential Carrier, Final Driven Gear Replacement; Carrier Bearing Replacement - Honda 2004 Odyssey Service Manual

A/T Differential
Differential Carrier, Final Driven
Gear Replacement
1. Remove the final driven gear from the differential
carrier.
NOTE: The final driven gear bolts have left-hand
threads.
2. Install the final driven gear with the chamfered side
on the inner bore facing the differential carrier.
3. Tighten the bolts to the specified torque in a
crisscross pattern.
Torque: 101 N·m (10.3 kgf·m, 74.5 lbf·ft)
14-478 14-478

Carrier Bearing Replacement

Special Tools Required
Attachment, 40 x 50 mm 07LAD-PW50601
NOTE:
• The bearing and outer race should be replaced as a
set.
• Inspect and adjust the bearing preload whenever
bearing is replaced.
• Check the bearing for wear and rough rotation. If the
bearing is OK, removal is not necessary.
1. Remove the carrier bearing (A) with a commercially
available bearing puller (B), bearing separator (C),
and stepped adapter (D).
B
2. Install the new carrier bearings with the special tool
and a press.
NOTE:
• Press the bearing on until it bottoms.
• Use the small end of the special tool to install the
bearing.
• Press the bearing on securely so there is no
clearance between the bearing and the
differential carrier.
C
D
A
07LAD-PW50601