Sliding Door Latch Replacement - Honda 2004 Odyssey Service Manual

Doors
Sliding Door Lock Remote Control
Replacement
NOTE: Put on gloves to protect your hands.
1. Remove the sliding door outer handle (see page 20-
14).
2. Disconnect the door latch cable (A) and door auto-
close cable or lower roller latch cable (B). If
equipped, disconnect the door lock actuator
connector (C) and power release actuator
connector (D). Then remove the door lock remote
control (E) through the hole in the door. Take care
not to bend any of the cables.
A
B
A
D
C
3. Install the door lock remote control in the reverse
order of removal, and note these items:
• Make sure the actuator connector(s) are plugged
in properly, and each cable is connected securely.
• Make sure the door locks and opens properly.
• When reinstalling the door panel, make sure the
plastic cover is installed properly and sealed
around its perimeter.
4. For EX and EX-L models: Re-home the power
sliding doors (see page 22-291).
20-16 20-16
B
E

Sliding Door Latch Replacement

NOTE: Put on gloves to protect your hands.
1. Remove these items:
• Door panel (see page 20-13)
• Plastic cover, as necessary (see page 20-4)
2. Remove the bolts (A) and the bolts (B).
Disconnect the door latch cable (C). If equipped,
disconnect the auto-close cable (D), lower roller
lever cable (E), and power door closer connector (F).
Then remove the latch (G) through the hole in the
door.
Fastener Locations
A : Bolt, 3
'99-00 models '01-04 models
A
A
A
B
G
B
B
E
E
D
B : Bolt, 3
6 x 1.0 mm
8 N·m
(0.8 kgf·m,
6 lbf·ft)
C
C
D
F