Honda 2004 Odyssey Service Manual page 1018

8. Install the transmission range switch (A) on the
control shaft (B), then secure it with the bolts.
NOTE: Do not move the transmission range switch
when tightening the bolts.
E
A
B
9. Install the transmission range switch cover (C), and
the harness holder (D) on the end cover (E).
10. Connect the transmission range switch connector
(A), then install it on the connector bracket (B).
11. Install the harness clamp (C) on its bracket (D).
6 x 1.0 mm
12 N·m
(1.2 kgf·m, 8.7 lbf·ft)
D
C
6 x 1.0 mm
12 N·m
(1.2 kgf·m, 8.7 lbf·ft)
B
A
C
D
12. Turn the ignition switch ON (II). Move the shift lever
through all gears, and check the transmission
range switch synchronization with the A/T gear
position indicator.
13. Allow the wheels to rotate freely, then start the
engine.
14. Move the shift lever through all gears, and verify
the following:
• The engine will not start in any position other
than N or P.
• The back-up lights come on when the shift lever
is in the R position.
14-405