NOTE: Check bearings for wear and rough rotation lf
the bearings are OK, removal is not necessary'
'1. Remove the ball bearings using a bearing puller as
lnstall new ball bearings using the special tool as
NOTE: Drive the bearings squarely until they bot-
tom against the carrler.
DRIVER, 40 mm LD.
\ 1 ,
Final Driven Gear RePlacement
1, Remove the bolts in a crisscross pattern in several
steps, then remove the final driven gear from the
NOTE: The final driven gear bolts have left-hand
1 0 x 1 . 0 m m B O L T
1 o 1 N . m l l O . 3 k g f ' m , 7 4 5 l b f ' f t )
lnstall the final driven gear by tightening the bolts
in a crisscross pattern in several steps'