Honda 2004 Odyssey Service Manual page 1151

Power Steering
Steering Gearbox Removal (cont'd)
17. Pass the removed 12 mm flange bolt (A) through
the bolt hole of the mounting bracket (B), and hook
the rear engine mount (C) removed in step 16 on
the 12 mm flange bolt.
A
B
18. Attach a wood block (A) to the lower center of the
front subframe (B). Attach a jack to the center of the
wood block and support the front subframe
securely by raising the jack.
C
B
A
19. Loosen the four 14 mm special bolts (C) on the
front subframe so they are 30 mm (1.18 in.) from
the mounting surface (until the stepped part of
each bolt can be seen). Do not loosen the 14 mm
special bolts more than necessary.
17-32
C
30 mm (1.18 in.)
C
C
C
20. Remove the four 12 mm flange bolts from the front
stiffener plates (A).
A
21. Remove the two 12 mm flange bolts from the rear
stiffener plates (A).
A
A
A