Secondary Shaft Clearance Inspection - Honda 2004 Odyssey Service Manual

Shafts and Clutches

Secondary Shaft Clearance Inspection

1. Remove the O-rings from the shaft.
2. Assemble the thrust needle bearing (A), needle
bearing (B), 1st gear (C), thrust needle bearing (D),
38 x 56.5 mm splined washer (E), 32 mm cotters (F),
cotter retainer (G), and snap ring (H) on the
secondary shaft (I).
14-214
I
A
B
C
D
E
F
G
H
3. Measure the clearance between the 38 x 56.5 mm
splined washer (E) and cotters (F) with a feeler
gauge (J) in at least three places. Use the average
as the actual clearance.
Standard: 0.07 0.15 mm (0.003 0.006 in.)
F
J
4. If the clearance is out of standard, remove the
splined washer, and measure its thickness.
5. Select and install a new splined washer, then
recheck.
SPLINED WASHER, 38 x 56.5 mm
No. Part Number
1 90502-P0Z-000
2 90503-P0Z-000
3 90504-P0Z-000
4 90505-P0Z-000
5 90506-P0Z-000
6 90507-P0Z-000
J
E
C
Thickness
6.85 mm (0.270 in.)
6.90 mm (0.272 in.)
6.95 mm (0.274 in.)
7.00 mm (0.276 in.)
7.05 mm (0.278 in.)
7.10 mm (0.280 in.)