Honda 2004 Odyssey Service Manual page 1424

Trim Removal/Installation - Rear Side Upper Area
NOTE:
• Put on gloves to protect your hands.
• When prying with a flat-tip screwdriver, wrap it with protective tape to prevent damage.
• Take care not to bend or scratch the trim and panels.
1. Remove the trim as shown.
2. Install the trim in the reverse order of removal, and note these items:
• Replace any damaged clips.
• Push the clips into place securely.
• Apply liquid thread lock to the anchor bolt before reinstallation.
• Before installing the anchor bolt, make sure there are no twists or kinks in the seat belt.
• Before installing the quarter glass opening trim, fill the bottom of the channel with clear sealant in the area
indicated by the arrows.
Sealant: Cemedine P/N 08712-0004, or equivalent
Fastener Locations
A
: Clip, 1 B
(White)
HOOKS
B
B
RIGHT REAR PILLAR TRIM
Pull the upper portion of
rear side trim panel back,
as necessary.
: Clip, 6
QUARTER GLASS
(Black)
OPENING TRIM
TAILGATE
WEATHERSTRIP
HOOKS
B
B
B
A
B
A
QUARTER GLASS
OPENING TRIM
Remove the quarter glass
attachment pin.
LEFT REAR PILLAR TRIM
Pull the upper portion of
rear side trim panel back,
as necessary.
HOOK
SEALANT
1193 mm
(46.97 in.)
20 mm
A
(0.8 in.)
UPPER ANCHOR
COVER
A Portions
SECOND ROW SEAT BELT
UPPER ANCHOR BOLT
7/16-UNF
32 N·m (3.3 kgf·m, 24 lbf·ft)
QUARTER GLASS
OPENING TRIM
QUARTER PILLAR TRIM
Pull the upper portion of
rear side trim panel back,
as necessary.
SECOND ROW SEAT
BELT SHOULDER
ANCHOR ADJUSTER
A
SLIDING DOOR
OPENING TRIM
REAR SIDE
TRIM PANEL
20-59