Honda 2004 Odyssey Service Manual page 1412

11. Attach the upper corner fasteners (A) and lower
corner fasteners (B) with adhesive tape (3M 5312,
or equivalent) to the tailgate as shown.
Fastener Locations
A Fastener, 2
A
B
12. Set the rear window in the opening, and center it.
Make alignment marks (A) across the rear window,
tailgate and body with a grease pencil at the four
points shown. Be careful not to touch the rear
window where adhesive will be applied.
13. Remove the rear window.
B Fastener, 2
A
B
A
14. With a sponge, apply a light coat of glass primer
along the edge of the rear window (A) lower rubber
dam (B) as shown, then lightly wipe it off with
gauze or cheesecloth:
• With the printed dots (C) on the rear window as a
guide, apply the glass primer to both side
portions of the rear window.
• Do not apply body primer to the rear window,
and do not get tailgate and glass primer sponges
mixed up.
• Never touch the primed surfaces with your hands.
If you do, the adhesive may not bond to the rear
window properly, causing a leak after the rear
window is installed.
• Keep water, dust, and abrasive materials away
from the primed surface.
: Apply glass primer here.
12 mm (0.47 in.)
7 mm
(0.28 in.)
A
A
12 mm (0.47 in.)
10 mm
(0.39 in.)
2 mm
(0.08 in.)
C
B
A
(cont'd)
20-47