Honda 2004 Odyssey Service Manual page 1434

Dashboard
Instrument Panel Removal/
Installation
NOTE:
• When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the
related parts, to prevent damage.
• Take care not to scratch the dashboard and related
parts.
1. Remove these items:
• Driver's switch panel (see page 20-70)
• Center panel (see page 20-70)
2. Tilt the steering column down.
3. Remove the instrument panel (A).
–1 Remove the screws.
–2 Gently pull out along the top to release the
clips (B, C).
–3 Disconnect the hazard warning switch
connector (D) and clock connector (E). With
navigation system, disconnect the climate
control unit connector.
Fastener Locations
: Screw, 8 B : Clip, 3
B
B
4. Install the instrument panel in the reverse order of
removal, and note these items:
• Make sure each connector is plugged in properly.
• Push the clips into place securely.
C : Clip, 1
A
B
C
D E
Dashboard Lower Cover Removal/
Installation
NOTE:
• When prying with a flat-tip screwdriver, wrap it with
protective tape, and apply protective tape around the
related parts, to prevent damage.
• Take care not to scratch the dashboard and related
parts.
1. Remove the dashboard lower cover (A).
–1 Remove the screw.
–2 Gently pull down on the lower cover to release
the clips.
–3 If equipped, disconnect the air hose (B) and in-
car temperature sensor connector (C), then
remove the cover.
Fastener Locations
: Screw, 1 : Clip, 3
A
2. Install the lower cover in the reverse order of
removal, and note these items:
• Make sure the in-car temperature sensor
connector is plugged in properly, and the air
hose is connected properly (for some models).
• Push the clips into place securely.
B
C
20-69 20-69