Honda 2004 Odyssey Service Manual page 689

Automatic Transmission
DTC Troubleshooting (cont'd)
8. Disconnect the 3P connector from the lock-up
control solenoid valve/shift control solenoid valve
A assembly.
9. Check for continuity between the D7 and B20 or
B22 terminals.
PCM CONNECTORS
B (25P)
LG1 (BRN/BLK) LG2 (BRN/BLK)
Wire side of female terminals
Is there continuity?
YES Repair short to ground in the wire between
the D7 terminal and shift control solenoid
valve A.
NO Go to step 10.
10. Measure the resistance between the No. 1 terminal
of the lock-up control solenoid valve/shift control
solenoid valve A assembly connector and body
ground.
LOCK-UP CONTROL SOLENOID VALVE/
SHIFT CONTROL SOLENOID VALVE A
ASSEMBLY CONNECTOR (3P)
SH A (GRN/WHT)
Terminal side of male terminals
Is there 12 25
YES Check for an open in the wire between the D7
terminal and shift control solenoid valve A.
NO Replace the lock-up control solenoid valve-
shift control solenoid valve A assembly (see page
14-130).
14-76
SH A (BLU/YEL)
D (16P)
?
11. Turn the ignition switch ON (II).
12. Measure the voltage between the D5 and B20 or
B22 terminals.
PCM CONNECTORS
B (25P)
LG2 (BRN/BLK)
LG1 (BRN/BLK)
Wire side of female terminals
Is there battery voltage?
YES Check for loose terminal fit in the PCM
connectors. If necessary, substitute a known-good
PCM and recheck.
NO Check for blown No. 6 (15A) fuse in the
driver's under-dash fuse/relay box. If the fuse is OK,
repair open in the wire between the D5 terminal
and the driver's under-dash fuse/relay box.
VB SOL (BLK/YEL)
D (16P)