Front Door Outer Handle Replacement - Honda 2004 Odyssey Service Manual

Doors
Front Door Panel Removal/
Installation (cont'd)
5. Release the clips that hold the door panel (A) with a
commercially available trim pad remover (B), then
remove the door panel by pulling it upward.
Disconnect the speaker connector (C).
For '02-04 models: If equipped with a seat heater,
disconnect the seat heater switch subharness
connector (D).
Remove the door panel with as little bending as
possible to avoid creasing or breaking it.
12 mm
(0.47 in.)
1 mm
(0.04 in.)
Fasterner Locations
: Clip, 7
D
6. Install the door panel in the reverse order of
removal, and note these items:
• Replace any damaged clips.
• Push the clips into place securely.
• Make sure the connectors are plugged in
properly, and the inner handle rod is connected
properly.
• For '03-04 models: Reset the power window
control unit (see page 22-200).
• Check the window and power door lock
operations.
• For '02-04 models: If equipped with a seat
heaters, check for proper operation.
20-8 20-8
95 mm (3.74 in.)
B
45°
45 mm
(1.77 in.)
A
C
Front Door Outer Handle
Replacement
NOTE : Put on gloves to protect your hands.
1. Raise the glass fully.
2. Remove these items:
• Mirror mount cover, power mirror (see step 2 on
page 20-33), manual mirror (see step 2 on page
20-34)
• Door panel (see page 20-7)
• Plastic cover, as necessary (see page 20-2)
3. Remove the bolt, and pull the glass run channel (A)
away as necessary for '99-00 models, then remove
the center lower channel (B) by pulling it downward.
For '01-04 models: Remove it with center lower
glass run channel (C).
Fasterner Location
: Bolt, 1
6 x 1.0 mm
8 N·m
(0.8 kgf·m,
6 lbf·ft)
'99-00 models
B
'01-04 models
B
B
A
A
B