Heater Valve Cable Adjustment - Honda 2004 Odyssey Service Manual

Hide thumbs Also See for 2004 Odyssey:

Table of Contents

Heating/Air Conditioning

Heater Valve Cable Adjustment

1. From under the hood, open the cable clamp (A),

then disconnect the heater valve cable (B) from the

heater valve arm (C).

2. From under the dash, disconnect the heater valve

cable housing from the cable clamp (A), and

disconnect the heater valve cable (B) from the air

mix control linkage (C).

3. Set the temperature control dial or button on Max

Cool (60°F or 18°C) with the ignition switch ON (II).

4. Attach the heater valve cable (B) to the air mix

control linkage (C) as shown step 2. Hold the end of

the heater valve cable housing against the stop (D),

then snap the heater valve cable housing into the

cable clamp (A).

5. From under the hood, turn the heater valve arm (C)

to the fully closed position as shown, and hold it.

Attach the heater valve cable (B) to the heater valve

arm, and gently pull on the heater valve cable

housing to take up any slack, then install the heater

valve cable housing into the cable clamp (A).

Table of Contents