Honda 2004 Odyssey Service Manual page 1037

Transmission Housing
Housing and Shaft Assembly Removal (cont'd)
Special Tools Required
Housing puller 07HAC-PK40102
NOTE: Refer to the exploded view as needed during the
following procedure.
1. Remove the ATF dipstick guide pipe.
2. Remove the two bolts securing the reverse idler
gear shaft holder, then remove the reverse idler
gear shaft holder (A), shaft (B), and washer (C).
3. Remove the transmission housing mounting bolts,
transmission hangers, and harness clamp bracket.
4. Move the reverse idler gear (A) to disengage it from
the mainshaft and countershaft reverse gears.
NOTE: The transmission housing will not separate
from the torque converter housing if the reverse
idler gear is not moved.
14-424
5. Align the spring pin (A) on the control shaft (B) with
A
B
6. Install the special tool over the mainshaft, then
C
7. Remove the reverse idler gear, needle bearings,
8. Remove the countershaft 2nd gear, then remove
9. Remove the lock bolt securing the shift fork, then
10. Remove the secondary shaft subassembly. If the
A
11. Remove the countershaft subassembly.
12. Remove the mainshaft subassembly.
13. Remove the differential assembly.
14. Remove the output shaft (countershaft) speed
the transmission housing groove (C) by turning the
control shaft.
07HAC-PK40102
A
C
B
D
remove the transmission housing (D).
NOTE: If the top arm of your housing puller is too
short, replace it with Housing puller arm, 205 mm,
T/N 07SAC-P0Z0101.
and thrust washer from the transmission housing.
the countershaft reverse gear and the needle
bearing.
remove the shift fork with the reverse selector.
If the reverse selector hub is not press-fitted,
remove the reverse selector hub, countershaft 5th
gear, and needle bearing from the countershaft.
reverse selector hub is press-fitted, remove the
secondary shaft subassembly, countershaft
subassembly and mainshaft subassembly together.
sensor if necessary.