Shift Cable Adjustment - Honda 2004 Odyssey Service Manual

Hide thumbs Also See for 2004 Odyssey:

Table of Contents

Shift Cable Adjustment

SRS components are located in this area. Review the

SRS component locations, 2002 model (see page 23-19),

2003-2004 models (see page 23-20), and the

precautions and procedures (see page 23-21) in the SRS

before performing repairs or service.

1. Remove the steering column covers (see page 17-

2. Shift the transmission into the N position.

3. Remove the nut (A) securing the shift cable end (B),

then separate the shift cable (C) from the shift lever

assembly (D).

4. Rotate the socket holder (E) on the shift cable

counterclockwise a quarter turn, then slide the

holder to remove the shift cable from the shift cable

bracket (F).

NOTE: Do not remove the shift cable by twisting

the shift cable guide (G).

5. Push the shift cable until it stops, then release it.

Pull the shift cable back two steps so that the shift

lever position is in N.

6. Turn the ignition switch ON (II), and verify that the

N position indicator comes on.

7. Turn the ignition switch OFF.

8. Insert a 6.0 mm (0.24 in.) pin (A) through the

positioning hole (B) on the detent plate and into the

positioning hole (C) on the control bracket.

Table of Contents