Honda 2004 Odyssey Service Manual page 1191

Rear Suspension
Hub/Bearing Replacement (cont'd)
REAR DISC BRAKE TYPE: '02-04 models
1. Loosen the wheel nuts slightly.
2. Raise the rear of the vehicle, and support it with
safety stands in the proper locations
(see page 1-15).
3. Remove the wheel nuts (A) and rear wheel (B).
4. Remove the caliper mounting bolts, and hang the
caliper assembly (A) to one side. To prevent
damage to the caliper assembly or brake hose, use
a short piece of wire to hang the caliper from the
undercarriage.
A
18-24
5. Press the parking brake pedal.
6. Remove the hub cap (A).
B
7. Raise the locking tab on the spindle nut (B), then
A
12 x 1.25 mm
108 N·m
8. Remove the drum in brake disc retaining screws (A).
(11.0 kgf·m,
79.6 lbf·ft)
9. Release the parking brake pedal, and remove the
10. Screw two 8 x 1.25 mm bolts into the drum in brake
12 x 1.25 mm
55 N·m (5.6 kgf·m,
41 lbf·ft)
remove the nut.
drum in brake disc.
disc to push it away from the hub. Turn each bolt
two turns at a time to prevent cocking the drum in
brake disc excessively.
A
B
24 x 1.5 mm
245 N·m
(25.0 kgf·m,
181 lbf·ft)
8 x 1.25 mm
A
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)