Honda 2004 Odyssey Service Manual page 845

Transmission End Cover
End Cover and Idler Gear Installation (cont'd)
5. Remove the bearing hub/bearing assembly (A) with
a puller (B).
B
A
6. Install the thrust needle bearing (A), needle bearing
(B), countershaft idler gear (C), thrust needle
bearing (D), bearing hub/bearing assembly (E), and
the old conical spring washer (F). Then tighten the
old locknut (G) to 164 N·m (17.0 kgf·m, 123 lbf·ft).
NOTE: Use a torque wrench to tighten the locknut.
Do not use an impact wrench.
G
E
D
B
A
14-232
F
C
7. Set the dial indicator (A) to the countershaft idler
gear (B) as shown.
8. Measure the countershaft idler gear axial clearance
in at least three places, while moving the
countershaft idler gear.
Use the average as the actual clearance.
Standard: 0.015 0.045 mm (0.0006 0.0018 in.)
A
B