Honda 2004 Odyssey Service Manual page 994

14. Install a new set ring (A) on the right driveshaft (B).
B
A
15. Install the right and left driveshaft. While installing
the left driveshaft in the differential, be sure not to
allow dust or other foreign particles to enter the
transmission.
NOTE:
• Clean the areas where the left driveshaft contacts
the transmission (differential) with solvent or
carburetor cleaner, and dry with compressed air.
• Turn the right and left steering knuckle fully
outward, and slide the left driveshaft into the
differential until you feel its spring clip engage
the side gear. Slide the right driveshaft into the
intermediate shaft until you feel its spring clip
engage the intermediate shaft.
16. Support the front subframe with the front subframe
adapter (T/N EQS07AODSY0) and a jack, and a lift it
up to the body.
17. Loosely install the subframe mounting bolts (4) (A)
A
14 x 1.5 mm
103 N·m
(10.5 kgf·m,
75.9 lbf·ft)
Replace.
EQS07AODSY0
and the 12 x 1.25 mm bolts (6) (B) with the
stiffeners (C), then tighten the bolts to the specified
torque by aligning all reference marks (D).
B
12 x 1.25 mm
74 N·m (7.5 kgf·m, 54 lbf·ft)
C
A
B
12 x 1.25 mm
117 N·m (11.9 kgf·m, 86.1 lbf·ft)
D
C
A
B
12 x 1.25 mm
117 N·m
(11.9 kgf·m,
86.1 lbf·ft)
D
(cont'd)
14-381