Driveshaft Disassembly - Honda 2004 Odyssey Service Manual

Driveshaft Disassembly

Special Tools Required
Threaded adapter, 24 x 1.5 mm 07XAC-001020A
Inboard Joint Side
1. Remove the set ring from the inboard joint.
2. Remove the boot bands. Be careful not to damage
the boot.
• If the boot band is a locking tab type (A), pry up
the locking tabs (B) with a screwdriver, and lift up
the end of the band.
• If the boot band is a double loop type (C), lift up
the band end (D).
Locking tab type
A
B
Double loop type
D
3. Make a mark (A) on each roller (B) and inboard joint
(C) to identify the locations of rollers and grooves
in the inboard joint. Then remove the inboard joint
on the shop towel (D). Be careful not to drop the
rollers when separating them from the inboard
joint.
C
D
A
C
A
B
(cont'd)
16-5