Honda 2004 Odyssey Service Manual page 1277

ABS Components
Modulator Unit Removal and Installation
NOTE:
• Do not spill brake fluid on the vehicle; it may damage the paint; if brake fluid gets on the paint, wash it off
immediately with water.
• Take care not to damage or deform the brake lines during removal and installation.
• To prevent the brake fluid from flowing, plug and cover the hose ends and joints with a shop towel or equivalent
material.
Removal
1. Remove the intake air duct (see step 6 on page 5-3).
2. Disconnect the modulator unit connector (A) and the pump motor connector (B).
3. Disconnect the brake lines, then remove the modulator unit (C).
Installation
1. Install the modulator unit, then connect the brake lines. Tighten the flare nuts to 15 N·m (1.5 kgf·m, 11 lbf·ft).
2. Connect the modulator unit connector and the pump motor connector.
3. Bleed the brake system, starting with the front wheels.
4. Reinstall the intake air duct (see step 48 on page 5-20).
5. Start the engine, and check that the ABS indicator goes off.
6. Test-drive the vehicle, and check that the ABS indicator does not come on.
19-76
From
right-rear
From
left-rear
From
right-front
B
A
From
left-front
C
6 mm NUT
9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)