9. Install the transmission range switch (A) gently on
the control shaft (B), then secure it with the bolts.
NOTE: Take care not to move the transmission
range switch when tightening the bolts.
E
D
A
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
B
10. Install the transmission range switch cover (C), and
the harness clamp (D) on the end cover (E).
11. Connect the transmission range switch connector
(A), then install it on the connector bracket (B).
6 x 1.0 mm
12 N·m (1.2 kgf·m,
8.7 lbf·ft)
C
A
B
12. Turn the ignition switch ON (II). Move the shift lever
through all gears, and check the transmission
range switch synchronization with the A/T gear
position indicator.
13. Start the engine. Move the shift lever through all
gears, and verify the following:
• The engine will not start in any position, other
than the N or P.
• The back-up lights come on when the shift lever
is in the R position.
14-175