Countershaft Disassembly, Inspection, And Reassembly - Honda 2004 Odyssey Service Manual

Countershaft Disassembly, Inspection, and Reassembly

1. Remove the locknut, and take off components down to the reverse selector hub.
2ND GEAR
REVERSE GEAR
NEEDLE BEARING
REVERSE SELECTOR
REVERSE SELECTOR HUB
4TH GEAR
NEEDLE BEARING
SNAP RING
DISTANCE COLLAR
COUNTERSHAFT
2. Remove the reverse selector hub, 3rd gear, and 1st gear (see page 14-210).
3. Check the bearing in the bearing hub for wear and rough movement. If the bearing is worn or damaged, replace it
(see page 14-212).
4. Inspect the thrust needle bearing and the needle bearing for galling and rough movement.
5. Check the splines for excessive wear and damage.
6. Check the shaft bearing surfaces for scoring, scratches, and excessive wear.
7. Lubricate all parts with ATF, and reassemble the shafts and gears.
8. Install the conical spring washer, reverse selector, reverse selector hub, and distance collar in the direction shown.
CONICAL SPRING WASHER
Replace.
BALL BEARING
COTTERS, 31 mm
3RD GEAR
1ST GEAR
LOCKNUT (FLANGE NUT)
Replace.
Left-hand threads
226 N·m (23.0 kgf·m, 166 lbf·ft) 0
167 N·m (17.0 kgf·m, 123 lbf·ft)
BEARING HUB
Selective part
THRUST NEEDLE BEARING
IDLER GEAR
NEEDLE BEARING
THRUST NEEDLE
BEARING
PARK GEAR
TRANSMISSION HOUSING
BEARING
14-209