Honda 2004 Odyssey Service Manual page 1182

25. Install the hub (A) onto the knuckle (B) using the
special tools shown and a hydraulic press. Be
careful not to distort the splash guard (C).
B
26. Install the knuckle in the reverse order of removal,
and pay particular attention to the following items:
• Be careful not to damage the ball joint boots
when installing the knuckle.
• Torque all mounting hardware to the specified
torque values.
• Torque the castle nuts to the lower torque
specifications, then tighten them only far enough
to align the slot with the ball joint pin hole. Do
not align the castle nut by loosening it.
• Install new lock pins on the castle nuts after
torquing.
• Raise the locking tab on the spindle nut, then
remove the nut.
• Before installing the brake disc, clean the mating
surface of the front hub and the inside of the
brake disc.
• Before installing the new spindle nut, apply a
small amount of engine oil to the seating surface
of the nut. After tightening, use a drift to stake the
spindle nut shoulder against the driveshaft.
• Before installing the wheel, clean the mating
surface of the brake disc and the inside of the
wheel.
• Check the front wheel alignment, and adjust it if
necessary (see page 18-5).
Press
07749-0010000
07746-0010500
C
A
07965-SD90100
18-15