Honda 2004 Odyssey Service Manual page 1429

Interior Trim
Headliner Removal/Installation (cont'd)
13. Detach the clips (A). If applicable, detach the clip (B)
and pull up the joint (C). Remove the rear pillar duct
(D) from the headliner (E).
Fastener Locations
A : Clip, 2 B
NOTE: Do not push
the inner clip in too far.
D
B
20-64
: Clip, 1
CLIP
INNER
CLIP
A
E
A
C
14. Remove the headliner:
–1 Remove the upper portion of the center p illar
trim (A) from each side (see page 20-58).
–2 Remove the rear roof trim (B).
–3 Remove the headliner (C) through the tailgate
opening.
C
A
A
15. Install the headliner in the reverse order of removal,
and note these items:
• When reinstalling the headliner through the
tailgate opening, be careful not to fold or bend it.
Also, be careful not to scratch the body.
• If the threads on a visor, grab handle, or
headliner (rear A/C passenger control panel
opening) mounting ET screws are worn out, use
an oversized ET screw made specifically for this
application.
Visor or grab handle mounting ET screw:
P/N 90137-S30-0030
Headliner mounting ET screw:
P/N 90133-SZ4-0030
• Check that both sides of the headliner are
securely attached to the trim.
B