Honda 2004 Odyssey Service Manual page 1465

Seats
Front Passenger's Seat Riser Disassembly/Reassembly (cont'd)
'03-04 models
The front passenger's weight sensor (SWS) unit must be calibrated after any of these actions (see page 23-42):
• Front passenger's seat replacement (including any seat components)
• Replacement of the seat weight sensors
• Replacement of the seat weight sensor unit
NOTE:
• When tightening the weight sensor mounting nuts, starting at the rear, tighten the nuts in the sequence shown.
• Make sure the weight sensor unit connectors are plugged in properly.
6 x 1.0 mm
9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)
CLIPS
(Four places)
OUTER RISER COVER
SEAT RISER
8 x 1.25 mm
21 N·m (2.1 kgf·m,
15 lbf·ft)
NAVIGATION UNIT
(For some models)
UNDER SEAT STORAGE TRAY
(For some models)
20-100
OUTER WEIGHT
SENSOR
WEIGHT
SENSOR
UNIT
8 x 1.25 mm
21 N·m (2.1 kgf·m,
15 lbf·ft)
6 x 1.0 mm
9.8 N·m (1.0 kgf·m,
7.2 lbf·ft)
HOOK
CENTER TABLE
INNER COVER
INNER WEIGHT
SENSOR
CLIPS
Replace.
8 x 1.25 mm
22 N·m (2.2 kgf·m,
16 lbf·ft)
CLIPS
(Four places)
INNER RISER COVER
UNDER SEAT STORAGE
TRAY GUIDE
(For some models)
HOOK
6 x 1.0 mm
9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)
CENTER TABLE
(For some models)
CENTER TABLE ARM
OUTER COVER
CLIPS
Replace.
CLIPS
Replace.