Shift Cable Replacement - Honda 2004 Odyssey Service Manual

Automatic Transmission

Shift Cable Replacement

SRS components are located in this area. Review the
SRS component locations (see page 23-18), and the
precautions and procedures (see page 23-21) in the SRS
before performing repairs or service.
1. Raise the front of the vehicle, and make sure it is
securely supported.
2. Set the parking brake, and block the rear wheels
securely.
3. Remove the steering column covers (see page 17-
25).
4. Shift the transmission into the N position.
5. Remove the nut (A) securing the shift cable end (B),
then separate the shift cable (C) from the shift lever
assembly (D).
D
B
A
6. Rotate the socket holder (E) on the shift cable
counterclockwise a quarter turn, then slide the
holder to remove the shift cable from the shift cable
bracket (F).
14-160
F
C
E
7. Remove the shift cable guide bracket (A) and
grommet (B).
6 x 1.0 mm
9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)
B
8. Remove the bolts securing the shift cable holder (A),
then remove the shift cable cover (B).
NOTE: To prevent damage to the control lever joint,
remove the bolts securing the shift cable holder
before removing the bolts securing the shift cable
cover.
E
A
D
9. Remove the lock bolt (C) securing the control lever
(D), then remove the shift cable (E) with the control
lever.
A
B
C