Transmission Housing
Shaft Assembly and Housing Installation (cont'd)
8. Align the spring pin (A) on the control shaft (B) with
the transmission housing groove (C) by turning the
control shaft.
10 x 1.25 mm
C
44 N·m (4.5 kgf·m, 33 lbf·ft)
A
17 Bolts
I
B
D
E
D
9. Install three dowel pins (D) and a new gasket (E) on
the torque converter housing (F).
10. Place the transmission housing (G) on the torque
converter housing, then install the transmission
housing mounting bolts along with the harness
clamp bracket (H) and transmission hangers (I).
11. Tighten the mounting bolts in two or more steps in
a crisscross pattern.
14-468
H
I
G
J
D
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
F
12. Install the new O-ring on the output shaft
(countershaft) speed sensor (J), then install it in the
transmission housing.
13. Engage the reverse idler gear with the countershaft
reverse gear and mainshaft reverse gear. Then
install the needle bearings (A), reverse idler gear
shaft (B), and thrust washer (C) in the reverse idler
gear, and install the reverse idler gear shaft holder
(D) on the transmission housing.
8 x 1.25 mm
26 N·m (2.7 kgf·m,
20 lbf·ft)
D
B
C
A