Honda 2004 Odyssey Service Manual page 1407

Glass
Windshield Replacement (cont'd)
14. Attach the molding corner seal (A) to the inside
surface of the molding (B) as shown:
• Be sure the molding upper seal and molding side
seal line up with the alignment dots (C).
• Be careful not to touch the windshield where
adhesive will be applied.
C
A
20-42
20 mm (0.79 in.)
B
B
15. Install the fasteners to the body.
Fastener Locations
: Fastener, 2
16. Set the windshield in the opening, and center it.
Make alignment marks (A) across the windshield
and body with a grease pencil at the four points
shown. Be careful not to touch the windshield
where adhesive will be applied.
17. Remove the windshield.
A