Honda 2004 Odyssey Service Manual page 1439

Dashboard
Dashboard Removal/Installation (cont'd)
8. Disconnect the side wire harness connectors (A), engine compartment wire harness connectors (B), door wire
harness connectors (C), dashboard wire harness connectors (D), steering hanger beam wire harness connectors
(E), brake switch connectors (F), parking brake switch connector (G), SRS wire harness connector (H), mode motor
connector (I), ECM/PCM connector ('99-00 models) or connectors ('01-04 models) (J), PCM subharness connector
(K) ('99-00 models), evaporator temperature sensor connector (L), air mix control motor connector (M),
recirculation control motor connector (N), blower relay connector (O) power transistor connector (P), blower
motor connector (Q) and antenna lead (R). For '00-04 models with navigation system: Disconnect the navigation
unit harness connector (S) and GPS antenna connector (T).
Fastener Locations
: Harness clip and connector clip
B
A
A
9. For '00-04 models with navigation system: Pull the carpet back as necessary (see page 20-65), and remove the
harness cushions (U), then pull the GPS antenna harness (V) out.
10. Using a Torx, T30 bit, remove the ground bolt (W) at the SRS control unit.
11. Detach all of the harness and connector clips.
20-74
F
G
E
C
W
6 x 1.0 mm
B
9.8 N·m
(1.0 kgf·m,
H
7.2 lbf·ft)
B
T
I
J
J
M
E
S
K
H
R
U
U
C
V
B
A
B
L
N
O
P
Q
E
D
H
D