Atf Level Check - Honda 2004 Odyssey Service Manual

ATF Level Check

NOTE: Keep all foreign particles out of the transmission.
1. Warm up the engine to normal operating
temperature (the radiator fan comes on).
2. Park the vehicle on the level ground. Turn off the
engine.
NOTE: Check the fluid level within 60 90 seconds
after turning the engine off.
3. Remove the dipstick (yellow loop) (A) from the
transmission, and wipe it with a clean cloth.
A
4. Insert the dipstick into the transmission.
5. Remove the dipstick and check the fluid level. It
should be between the upper mark (B) and lower
mark (C).
6. If the level is below the lower mark, check for fluid
7. If necessary, fill the transmission into the filler hole
8. If the level is above the upper mark, drain the ATF
9. Install the ATF filler bolt (B) with a new sealing
10. Insert the dipstick back into the transmission.
B
C
leaks at the transmission, hose and line joints. If a
problem is found, fix it before filling the
transmission.
(A) to bring the fluid level up to the upper mark.
Always use Honda ATF-Z1 Automatic Transmission
Fluid (ATF). Using a non-Honda ATF can affect shift
quality.
B
24 x 1.5 mm
44 N·m
(4.5 kgf·m,
33 lbf·ft)
to proper level (see step 3 on page 14-368).
washer (C).
C
A
14-367