Honda 2004 Odyssey Service Manual page 754

25. Remove the oxygen sensor connectors (A) from
their connector brackets (B), and remove the
harnesses from the clamps (C).
B
E
A
26. Remove the exhaust pipe A (D) and three way
catalytic converter (E).
27. Remove the spring pins (A) and castle nuts (B), and
separate the lower arms (C) from the knuckles (D)
(see page 18-11).
A
B
D
C
28. Put a 6 mm Allen-type wrench (E) in the top of the
ball joint pin (F), and remove the nut (G), then
separate the stabilizer link (H).
A
B
D
C
C
E
G
H
F
29. Remove the bolts securing the shift cable holder (A),
then remove the shift cable cover (B).
NOTE: To prevent damage to the control lever (C),
remove the bolts securing the holder before
removing the bolts securing the cover.
E
A
D
30. Remove the lock bolt (D) securing the control lever,
then remove the shift cable (E) with the control
lever. Do not bend the shift cable excessively.
31. Install a 6 x 1.0 x 14 mm bolt (A) and nut (B) on the
shift cable cover (C), then reinstall the shift cable
cover to the torque converter housing.
If you don't do this, the bolt head of the cable cover
may prevent you from removing the torque
converter during transmission removal.
B
A
C
B
C
(cont'd)
14-141