Honda 2004 Odyssey Service Manual page 1200

Removal
1. Raise the rear of the vehicle, and support it with
safety stands in the proper locations
(see page 1-15). Remove the rear wheel.
2. Position a floor jack at the connecting point of the
lower arm (B) and the knuckle.
3. Remove the wheel sensor (A) from the lower arm B.
Do not disconnect the wheel sensor connector.
4. Remove the flange bolt (C) that connects the lower
arm B and the knuckle.
5. Lower the floor jack gradually.
6. Remove the spring (A), upper spring seat (B), and
lower spring seat (C).
7. Remove the self-locking nut (D) and flange bolt(E).
B
A
C
E
D
B
A
C
8. Remove the flange bolt (A) that connects to the
body, and remove the bump stop (B).
B
A
(cont'd)
18-33