Honda 2004 Odyssey Service Manual page 848

26. Install the end cover (A) with the two dowel pins,
new O-rings, new gasket, and harness clamp
bracket (B). Tighten the 16 bolts to 12 N·m, (1.2
kgf·m, 8.7 lbf·ft).
27. Set the transmission range switch to N position.
NOTE: The transmission range switch clicks in N
position.
28. Set the control shaft (A) to the N position by turning
B
A
it.
NOTE: Be careful not to squeeze the end of the
control shaft tips together when turning into
position. If the tips are squeezed together it will
cause a faulty shift signal or position due to the
play between the control shaft and position switch.
A
(cont'd)
14-235