Compressor Relief Valve Replacement - Honda 2004 Odyssey Service Manual

5. Reassemble the clutch in the reverse order of
disassembly, and note these items:
• Install the field coil with the wire side facing
down, and align the boss on the field coil with the
hole in the compressor.
• Clean the pulley and compressor sliding surfaces
with contact cleaner or other non-petroleum
solvent.
• Install new snap rings, note the installation
direction, and make sure they are fully seated in
the groove.
• Make sure that the pulley turns smoothly after it's
reassembled.
• Route and clamp the wires properly or they can
be damaged by the rotor pulley.
Compressor Relief Valve
Replacement
1. Recover the refrigerant with a recovery/recycling/
charging station (see page 21-56).
2. Remove the relief valve (A) and the O-ring (B). Plug
the opening to keep foreign matter from entering
the system and the compressor oil from running
out.
A
13.2 N·m (1.35 kgf·m, 9.76 lbf·ft)
3. Clean the mating surfaces.
4. Replace the O-ring with a new one at the relief
valve, and apply a thin coat of refrigerant oil before
installing it.
5. Remove the plug, and install and tighten the relief
valve.
6. Charge the system (see page 21-58).
B
21-53 21-53