Front Door Glass Adjustment - Honda 2004 Odyssey Service Manual

Front Door Glass Adjustment

NOTE:
• Check the weatherstrips and glass run channel for
damage or deterioration, and replace them if
necessary.
• Wipe the run channel clean with a shop towel.
• Lubricate the run channel with Shin-Etsu grease
P/N 08798-9013.
1. Place the vehicle on a firm, level surface.
2. Remove these items:
• Door panel (see page 20-7)
• Pull pocket bracket (see page 20-2)
• Power window control unit bracket, '03-04
models driver's door (see page 20-2)
• Plastic cover (see page 20-2)
3. Carefully lower the glass (A) until you can see the
glass mounting bolts (B), then loosen them.
B
6 x 1.0 mm
9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)
4. Push the glass (A) against the center channel (C),
then tighten the glass mounting bolts.
5. Check that the glass moves smoothly.
C
A
6. Raise the glass fully, and check for gaps. Check that
the glass (A) contacts the glass run channel (B)
evenly.
B
A
7. Check for water leaks. Run water over the roof and
on the sealing area as shown, and note these items:
• Use a 12 mm (1/2 in.) diameter hose (A).
• Adjust the rate of water flow as shown (B).
• Do not use a nozzle.
• Hold the hose about 300 mm (12 in.) away from
the door.
12 mm (1/2 in.)
A
300 mm (12 in.)
8. Attach the plastic cover, and install the door panel
(see page 20-7).
9. Test-drive and check for wind noise.
0.5 m (18 in.)
B
20-23