Honda 2004 Odyssey Service Manual page 1419

Glass
Sliding Door Glass Replacement (cont'd)
18. Use suction cups (A) to hold the sliding door glass
over the opening, align it and set it down on the
adhesive. Lightly push on the sliding door glass
until its edges are fully seated on the adhesive all
the way around. Do not open or close the doors
until the adhesive is dry.
19. Scrape or wipe the excess adhesive off with a putty
knife or towel. To remove adhesive from a painted
surface or the rear window, use a soft shop towel
dampened with alcohol.
20. Let the adhesive dry for at least 1 hour, then spray
water over the sliding door glass and check for
leaks. Mark any leaking areas, let the sliding door
glass dry, then seal with sealant. Let the vehicle
stand for at least 4 hours after sliding door glass
installation. If the vehicle has to be used within the
first 4 hours, it must be driven slowly.
21. Reinstall all remaining removed parts.
NOTE: Advise the customer not to do the following
things for 2 to 3 days:
• Slam the doors with all the windows rolled up.
• Twist the body excessively (such as when going
in and out of driveways at an angle or driving
over rough, uneven roads).
20-54
A