Road Test - Honda 2004 Odyssey Service Manual

Road Test

Special Tools Required
Backprobe set 07SAZ-001000A (two required)
1. Warm up the engine to normal operating
temperature (the radiator fan comes on).
2. Apply the parking brake, and block both rear
wheels. Start the engine, then shift to the D position
while pressing the brake pedal. Press the
accelerator pedal, and release it suddenly. The
engine should not stall.
3. Repeat step 2 in the D3 position.
4. Connect the HDS to the DLC (A), and go to the
PGM-FI Data List; then go to step 7. If you don't
have a HDS, go to step 5.
A
5. Pull back the carpet, and remove the passenger's
and driver's side center lower covers to expose the
PCM (see page 11-4).
6. Remove the PCM cover from the passenger's side
under-dash fuse to access the PCM mounting nut.
7. Remove the PCM mounting bolt, then remove the
PCM.
8. Connect a digital multimeter (A) and the special
tools (B) to check voltage between these PCM
connector terminals.
• 1999-2000 models: Between PCM connector
terminals C27 and B20 or B22.
• 2001 model: Between PCM connector terminals
A15 and A25 or A26.
A
1999-2000 models:
PCM CONNECTORS
B (25P)
C (31P)
LG2 (BRN/BLK)
LG1 (BRN/BLK)
Wire side of female terminals
2001 model:
PCM CONNECTOR A (31P)
TPS (RED/BLK)
LG2 (BRN/BLK) LG1 (BRN/BLK)
Wire side of female terminals
B
07SAZ-001000A
TPS (RED/BLK)
(cont'd)
14-125