Countershaft Reverse Selector Hub, 3Rd Gear, And 1St Gear Installation - Honda 2004 Odyssey Service Manual

Countershaft Reverse Selector Hub, 3rd Gear, and 1st Gear Installation

Special Tools Required
Driver, 40 mm I.D. 07746-0030100
1. Apply ATF to the parts.
2. Align the shaft splines with those on 1st gear, then
press the countershaft (A) into the 1st gear (B) with
a press.
• Place an attachment (C) between the press and
countershaft to prevent damaging the
countershaft.
• Stop pressing the countershaft when the 1st gear
contacts the final drive gear (D).
C
B
3. Align the shaft splines with those on 3rd gear, then
press the countershaft into the 3rd gear with a
press.
• Place an attachment between the press and
countershaft to prevent damaging the
countershaft.
• Stop pressing the countershaft when the 3rd gear
contacts the 1st gear.
4. Install the 31 mm cotters, distance collar, snap ring,
needle bearing, and 4th gear (A) on the
countershaft.
5. Slide the reverse selector hub (B) over the
countershaft (C), and then press it into place with
the special tool and a press.
NOTE: Some reverse selector hubs are not press-
fitted and can be installed without using the special
tool and a press.
A
D
07746-0030100
B
A
C
14-211