Honda 2004 Odyssey Service Manual page 1313

ABS/TCS Components
DTC Troubleshooting
ABS DTC 11, 13, 15, 17:
Short to Body Ground/Short to Power)
1. Disconnect the ABS/TCS control unit connector A
(26P).
2. Start the engine.
3. Measure the voltage between the appropriate
wheel sensor ( ) circuit terminal and body ground
(see table).
DTC
11 (Right-front)
13 (Left-front)
15 (Right-rear)
17 (Left-rear)
ABS/TCS CONTROL UNIT CONNECTOR A (26P)
FLW ( ) (GRN/BLU)
RLW ( ) (LT BLU)
Wire side of female terminals
Is there 2 V or more?
YES Repair short to power in the ( ) circuit wire
between the ABS/TCS control unit and the
appropriate wheel sensor.
NO Go to step 4.
19-112
Wheel Sensor (Open/
Appropriate Terminal
No. 11 : FRW ( )
No. 9 : FLW ( )
No. 23 : RRW ( )
No. 21 : RLW ( )
FRW ( ) (GRN/BLK)
RRW ( )
(GRN/YEL)
4. Check for continuity between the appropriate
wheel sensor ( ) circuit terminal and body ground
(see table).
DTC
11 (Right-front)
13 (Left-front)
15 (Right-rear)
17 (Left-rear)
ABS/TCS CONTROL UNIT CONNECTOR A (26P)
FLW ( ) (GRN/BLU)
RLW ( )
(LT BLU)
Wire side of female terminals
Is there continuity?
YES Go to step 5.
NO Go to step 6.
5. Disconnect the harness 2P connector from the
appropriate wheel sensor, then check for continuity
between the ( ) and ( ) terminals of the harness
and body ground.
Is there continuity?
YES Repair short to body ground in the ( ) or ( )
circuit wire between the ABS/TCS control unit and
the wheel sensor.
NO Replace the wheel sensor.
Appropriate Terminal
No. 11 : FRW ( )
No. 9 : FLW ( )
No. 23 : RRW ( )
No. 21 : RLW ( )
FRW ( ) (GRN/BLK)
RRW ( )
(GRN/YEL)