Honda 2004 Odyssey Service Manual page 983

Automatic Transmission
Transmission Removal (cont'd)
13. Remove the ATF cooler hose (A) from the clamp (B)
on the starter, and paint a white dot (C) on the hose
where it came out of the clamp.
B
C
A
14. Remove the ATF cooler hose (A) from the ATF
cooler lines (D). Turn the ends of the ATF cooler
hoses up to prevent ATF from flowing out, then
plug the ATF cooler hoses and lines. Check for any
signs of leakage at the hose joints.
15. Remove the starter cables (A) from the starter (B),
then remove the starter.
A
14-370
16. Remove the harness clamps (B) from the brackets
A
C
D
A
17. Remove the 8P connector (C) from the connector
B
E
A
18. Remove the harness clamps (E) from the brackets
(D), then disconnect the connectors from the shift
solenoid valves A and C, A/T clutch pressure
control solenoid valve C (E), 4th clutch
transmission fluid pressure switch (F), and input
shaft (mainshaft) speed sensor (G).
D
B
bracket (D), then disconnect the connector.
A
B
F
E
F
(F), then disconnect the connectors from the A/T
clutch pressure control solenoid valves A and B.
B
G
E F
C
D
C