Honda 2004 Odyssey Service Manual page 966

10. Test-drive the vehicle on a flat road in the D
position. Check for abnormal noise and clutch
slippage. While driving, check that the shift points
occur at the proper speeds by monitoring the
throttle position sensor voltage and comparing
your shift point speeds and voltage to those in the
table. (The throttle position sensor voltage
represents the throttle opening.)
Upshift: D position
Throttle position sensor voltage: 0.75 V
1st 2nd 10 11 mph (16 18 km/h)
2nd 3rd 19 22 mph (31 35 km/h)
3rd 4th 26 30 mph (42 48 km/h)
4th 5th 45 48 mph (73 77 km/h)
Lock-up ON 48 50 mph (77 80 km/h)
Throttle position sensor voltage: 2.25 V
1st 2nd 30 31 mph (48 50 km/h)
2nd 3rd 47 50 mph (76 80 km/h)
3rd 4th 60 70 mph (106 112 km/h)
4th 5th 88 89 mph (141 143 km/h)
Lock-up ON 89 90 mph (143 145 km/h)
Fully-opened throttle
1st 2nd 40 43 mph (65 69 km/h)
2nd 3rd 67 70 mph (107 111 km/h)
3rd 4th 100 103 mph (161 165 km/h)
Downshift: D position
Throttle position sensor voltage: 0.75 V
Lock-up OFF 38 40 mph (61 65 km/h)
5th 4th 36 40 mph (58 61 km/h)
4th 3rd 17 19 mph (29 31 km/h)
2nd 1st 9 10 mph (15 17 km/h)
Throttle position sensor voltage: 2.25 V
Lock-up OFF 76 80 mph (123 129 km/h)
5th 4th 65 68 mph (105 109 km/h)
4th 3rd 40 41 mph (64 67 km/h)
3rd 2nd 23 25 mph (38 41 km/h)
2nd 1st 9 10 mph (15 17 km/h)
Fully-opened throttle
4th 3rd 88 92 mph (142 148 km/h)
3rd 2nd 56 60 mph (90 97 km/h)
2nd 1st 30 33 mph (48 54 km/h)
11. Accelerate to about 35 mph (57 km/h) so the
transmission is in 4th or 5th, then shift from the D
position to the 2 position. The vehicle should
immediately begin slowing down from engine
braking.
12. Check for abnormal noise and clutch slippage in
the following positions.
1 (1st Gear) Position
Accelerate from a stop at full throttle. Check that
there is no abnormal noise or clutch slippage.
Upshifts should not occur with the shift lever in this
position.
2 (2nd Gear) Position
Accelerate from a stop at full throttle. Check that
there is no abnormal noise or clutch slippage.
Upshifts and downshifts should not occur with the
shift lever in this position.
R (Reverse) Position
Accelerate from a stop at full throttle, and check for
abnormal noise and clutch slippage.
13. Test in P (Park) Position.
Park the vehicle on a slope (about 16°), apply the
brake, and shift into the P position. Release the
brake; the vehicle should not move.
14-353