Honda 2004 Odyssey Service Manual page 619

Automatic Transmission
General Troubleshooting Information (cont'd)
How to End a Troubleshooting Session
This procedure must be done after any troubleshooting.
1. Turn the ignition switch OFF.
2. Connect the Scan Tool or the HDS to the DLC.
3. Turn the ignition switch ON (II).
4. Clear the DTC(s) with the Scan Tool or the HDS.
NOTE: You can also reset the memory by removing
the No. 13 fuse in the passenger's under-dash fuse/
relay box for more than 10 seconds. If you do, you
need to do the following:
• Get the customer's radio and navigation (if
equipped) anti-theft code, and write down the
radio and navigation presets.
• Enter the radio and navigation (if equipped) anti-
theft code, reset the preset stations, and set the
clock.
• Do the idle learn procedure (see page 11-202).
5. To verify that the problem is repaired, test-drive the
vehicle for several minutes at speeds over 30 mph
(50 km/h) or under the same conditions as those
indicated by the freeze data.
14-6