Honda 2004 Odyssey Service Manual page 1087

Transmission End Cover
End Cover, 3rd Gear, Idler Gear, and 3rd Clutch Installation (cont'd)
39. Place the new ATF passage body gasket (A) on the
transmission housing, then install the 8 x 14 mm
dowel pin (B) and the 10 x 25.5 mm ATF feed pipe
(C) with the new O-ring (D). Install the ATF passage
body (E) on the transmission housing, if it was
removed.
A
14-474
B
E
C
D
6 x 1.0 mm
12 N·m
(1.2 kgf·m, 8.7 lbf·ft)
40. Install the new ATF filter (A) on the transmission
housing.
H
6 x 1.0 mm
G
9.8 N·m (1.0 kgf·m, 7.2 lbf·ft)
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft)
F
I
K
41. Install the filter line bracket (B) on the ATF filter,
and loosely install the bolts (C).
42. Install the new O-ring (D) to the filter line (E), then
install the filter line on the ATF filter.
43. Secure the end of the filter line on the bracket (F)
with the bolt (G).
44. Secure the filter line on the filter line bracket with
the bolts (H).
45. Tighten the bolts (C) on the filter line bracket to the
specified torque.
46. Install the ATF hose (I) and line bolt (J) with the new
sealing washers (K).
47. Connect the hose to the filter line, and secure it
with the clip (L).
E
C
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
D
7.2 lbf·ft)
B
A
22 N·m
L (2.2 kgf·m,
16 lbf·ft)
J
28 N·m
(2.9 kgf·m,
21 lbf·ft)