Honda 2004 Odyssey Service Manual page 1376

4. Detach the harness clip (A) and inner handle rod (B),
and disconnect the actuator connector (C).
Fastener Locations
: Screw, 3
6 x 1.0 mm
6 N·m
(0.6 kgf·m,
4 lbf·ft)
E
F
D
C
A
5. Remove the screws, then remove the latch (D)
through the hole in the door. Take care not to bend
the outer handle rod (E), cylinder rod (F), lock rod
(G) and inner handle rod (B).
6. Install the latch in the reverse order of removal, and
note these items:
• Make sure the actuator connectors are plugged in
properly, and each rod is connected securely.
• Make sure the door locks and opens properly.
• When reinstalling the door panel, make sure the
plastic cover is installed properly and sealed
around its perimeter.
• For '03-04 models: Reset the power window
control unit (see page 22-200).
Front Door Glass and Regulator
Replacement
G
B
1. Remove these items:
• Door panel (see page 20-7)
• Pull pocket bracket (see page 20-2)
• Power window control unit bracket, '03-04
models driver's door (see page 20-2)
• Plastic cover (see page 20-2)
2. Carefully raise the glass until you can see the bolts,
then remove them. Carefully pull the glass out
through the window slot. Take care not to drop the
glass inside the door.
Fastener Locations
: Bolt, 2
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
(cont'd)
20-11 20-11