Honda 2004 Odyssey Service Manual page 1385

Doors
Power Sliding Door Motor Unit Replacement (cont'd)
8. Remove the bolts securing the front pulley (A).
Fastener Locations
: Bolt, 4
6 x 1.0 mm
8 N·m
(0.8 kgf·m,
6 lbf ft)
9. Remove the nuts securing the rear pulley (B).
Fastener Locations
: Nut, 3
6 x 1.0 mm
8 N·m
(0.8 kgf·m,
6 lbf·ft)
20-20
A
B
10. Remove the bolts (A), loosen the bolts (B, C) and
move the bracket (D) upward. Disconnect the motor
unit connectors (E) and control unit connectors (F).
On the left door, disconnect the buzzer connector
(G). Remove the motor unit (H) through the body
opening. Take care not to kink the power sliding
door motor unit cable (I).
Fastener Locations
A : Bolt, 2
6 x 1.0 mm
8 N·m
(0.8 kgf·m,
6 lbf·ft)
C : Bolt, 2
6 x 1.0 mm
9.8 N·m
(1.0 kgf·m,
7.2 lbf·ft)
D
I
B
C
H
A
E
B : Bolt, 2
6 x 1.0 mm
8 N·m
(0.8 kgf·m,
6 lbf·ft)
F
B
C I
A
G